Tensile tests on thermoplastic pipes

ISO 6259

ISO 6259

Tests on pipes in HDPE material, using a machine with a capacity of up to 50KN

The reference Standard which determines the test methods and the specimen types is ISO 6259. The tested sample is obtained directly from a finished tube, with thickness up to 60 mm and outside diameters from a minimum of 15 mm up to diameters higher than 450 mm.

Test is performed on specimens’ type 1 obtained by machining, type 2 obtained by a die cutting machine and type 3 obtained by machining. The high performing fixture chosen by Galdabini engineering meets the tests on specimen’s type 3 (width 100 mm and thickness up to 60 mm), which foresees a hole made in the specimen ends by means of a standardized punch. For the other two types of specimens (type 1 and type 2) clamping is performed by wedge grips, of traditional concept, but with particularly wide opening thus considering the foreseen maximum thickness.

A self-supporting extensometer, model Micron has been installed on the machine for the measurement of stress at yield point and elongation at break, which are parameters required by ISO 6259.





¿Interesado en nuestras máquinas y soluciones? Contáctarnos